mdrVB6 wrote:Very nice but I should have clarified that I'm more interested in anyone who has gotten the full graphic smart controller working with their RUMBA and solidoodle firmware.
Sorry md, I was actually posting for OP since he was asking for help with the exact setup i have. Where did you get your library that's needed to be installed? They have it linked in my firmware.
// The RepRapDiscount FULL GRAPHIC Smart Controller (quadratic white PCB)
// http://reprap.org/wiki/RepRapDiscount_F … Controller
//
// ==> REMEMBER TO INSTALL U8glib to your ARDUINO library folder: http://code.google.com/p/u8glib/wiki/u8glib
//#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
Also, you should have that last line uncommented to define the correct LCD. This is from line 583 in my Configuration.h on the firmware i'm running.
EDIT: Further investigation shows just above these lines of LCD's there are a few defines you can uncomment for some settings.
//#define DOGLCD // Support for SPI LCD 128x64 (Controller ST7565R graphic Display Family)
I can't confirm but I'm fairly certain you should have that uncommented for your LCD as well as the one I already mentioned. @ line 556 in my configuration.h.
Bowden SD3, Rumba, E3D hotend, Mk5 with RtRyder changes, Direct drive Y axis and bearings, GT2 pulleys and braided fishing line, Lawsy linear bearing conversion, M3 Z screw.