Topic: Scan and print
Hi,
Using the 1.6 version of freelss and after a long calibration process, I can get this kind of results.
Parameters : 5M pixels still mode, 1200 frames, 6400 steps for revolution (my stepper is a 0.9°)
For the calibration I use, as Pirvan, a checkerboard pattern to be sure that lasers were perfectly aligned with the camera red pattern. Also use a personnal calibrator adapted from the model designed for the Atlas scanner.
Then I scan 50% of a tube and check under meslabs the diameter and adjust precisly, for each laser, the distance from camera center : a long but, in my opinion, imperative process.
Original :
Freelss preview :
Meshlabs brut ply file
Poisson reconstruction :
Process : poisson-disk sampling 250000/compute normals for point set 1000/surface reconstruction : poisson 12-7-1-1.
Netfabb basic cleaning and repair stl file :
Then printing (Support and raft ON, 0,20 layers, Infill 0%) :
Copy VS original :
Loosing some details (eyes and lips for example) but I must work harder to command Meshlabs.
Raspberry Pi 2
Piclop personnal design (check Website)
Direct RJ45 connection