Turntable slightly too wide

I'm printing the last of my parts now (4" turntable). The parts seem remarkably well designed and I had almost no problems printing them.

The only significant issue is on the turntable which is just a hair over 100 mm (101.6 to be exact). My Printrbot has a hard limit at 100 mm and so I had to scale it down by 2%. I don't think this will affect the fit of the attachment screws but it would be great if the design could be adjusted.

The rotation of the frame connector was wrong but, of course, this is not a real issue.

I'm really looking forward to getting my parts next month and completing this great project!

--Dave