1 Topic by w_smith

  • w_smith
  • Member
  • Offline
  • Registered: 2014-11-23
  • Posts: 97

Topic: On the lighter side: Cheese printing

http://techcrunch.com/2015/03/30/this-e … isruption/

Gotta watch the movie, absolutely great!  Lol!

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: On the lighter side: Cheese printing

Some people have too much time on their hands big_smile

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by Claghorn

  • Claghorn
  • Member
  • Offline
  • From: Delray Beach, FL
  • Registered: 2012-10-22
  • Posts: 730

Re: On the lighter side: Cheese printing

I was just googling and I can't believe no one makes an aerosol peanut butter to go with aerosol cheeze. You could make a great dual head printer with both of them :-).

Claghorn's Website