Re: E3D Volcano slicer settings
guy over on reddit who was printing 0.90 layers at 25 mm/s with the 1.2 nozzle.
That'd be 31.5mm^3/sec, assuming 1.4mm widths. Was he printing the same material as you?
The general limit on a v6 is about 15 mm^3/sec. I get occasionally missed steps when I push towards 20. I think 35-40mm^3/sec would be a good limit for Volcano, since the melt zone is roughly doubled.
Lots of learning for me today!
We're all learning together!