1 Topic by RaceGeek

  • RaceGeek
  • Member
  • Offline
  • Registered: 2014-04-24
  • Posts: 29

Topic: IGUS tribo-filament

I just picked up 2 different samples at the IGUS booth at MD&M (medical device mfg and tech convention)  their new low friction high abrassion resistant filament. I hope to get some test prints going this weekend. Anyone have any experience with it yet? Not sure what i would use it for but I may try printing some gears or something.

http://www.igus.com/wpck/11723/N14_4_1_ … boFilament

2 Reply by Fredjikrang

  • Fredjikrang
  • Member
  • Offline
  • Registered: 2015-01-16
  • Posts: 124

Re: IGUS tribo-filament

Cool! I have been hoping to hear something about it! I'm looking forward to reading about your experience with it!