1 Topic by Fredjikrang

  • Fredjikrang
  • Member
  • Offline
  • Registered: 2015-01-16
  • Posts: 124

Topic: Weird behavior

Has anyone seen this before?

https://www.dropbox.com/s/f158ue7r5rtz2 … 4.MOV?dl=0

2 Reply by jagowilson

  • jagowilson
  • PRINTiT
  • Offline
  • Registered: 2014-09-14
  • Posts: 1,701

Re: Weird behavior

Just a very fast travel/non print move. Perfectly normal.

3 Reply by Fredjikrang

  • Fredjikrang
  • Member
  • Offline
  • Registered: 2015-01-16
  • Posts: 124

Re: Weird behavior

Why would it make that move though?

4 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: Weird behavior

Just how it was sliced

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

5 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: Weird behavior

You most likely have random start points selected

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website