Topic: Da Vinci reboots while receiving job.
My brand new printer is starting to reboot while the .3w file uploads. Any suggestions?
Simplify3D
Stock FW
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing DaVinci → Da Vinci reboots while receiving job.
My brand new printer is starting to reboot while the .3w file uploads. Any suggestions?
I had this happen a few times as well with things I downloaded. I ran them through the model repair service or loaded them into sketch-up and re-exported them. It seemed to solve the problem for me.
I had this happen a few times as well with things I downloaded. I ran them through the model repair service or loaded them into sketch-up and re-exported them. It seemed to solve the problem for me.
I ended up loading in a different model, it worked. There must have been errors in the one that didn't work. Thanks.
I am week old noob here running the latest stock firmware/software from xyz.
What i have learned in the last few days of owning the 1.0 when it starts loading and suddenly stops.
1. Make sure when 1st import save and cancel, look and see the xyz software built the print job correctly and inspect the model in the 3d view. Make sure it touches the bed and no missing complete lines in the piece by rotating and zooming in.
2. Run it through the model repair from MS.
3. Try not moving the piece after import.
4. Leave the default print settings( This took me awhile to figure out on one small piece)
5. load the piece into another software like slic3r and do the inspection with its zoom(not a knock, but the detail and control of keeping it centered while zooming is helpful) It could possibly show you the model is broken by a very small section completely missing.
my .02
So far, I love this machine
SoliForum - 3D Printing Community → XYZ Printing DaVinci → Da Vinci reboots while receiving job.
Powered by PunBB, supported by Informer Technologies, Inc.