Topic: wiring and hooking up the Prusa i3 today
cant wait to use this badboy. its a blast building one
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → General Discussion → wiring and hooking up the Prusa i3 today
cant wait to use this badboy. its a blast building one
Post some pics of your progress!
here it is
Nice start! What are you using for the Motherboard?
What ever came in the kit. I think it uses arduino. Then the power source can be either 110 v or 220 v bc it has a switch to convert it to the 12 volt. I also used an all metal hot end which the cooling fan so I can finally do some PLA. Just got to finish hooking all these wires up and making them look pretty.
Nice start! What are you using for the Motherboard?
if it's the card on the left of the picture, it's a Melzi 2.0 card, sanguino compatible with soldered stepper drivers instead of removing ones and a ATMEGA1284P. ( v1.0 card are red, v2.0 are green , http://www.reprap.org/wiki/Melzi )
That is it. Could you tell me the steps to bootload it?
if it's the card on the left of the picture, it's a Melzi 2.0 card, sanguino compatible with soldered stepper drivers instead of removing ones and a ATMEGA1284P. ( v1.0 card are red, v2.0 are green , http://www.reprap.org/wiki/Melzi )
SoliForum - 3D Printing Community → General Discussion → wiring and hooking up the Prusa i3 today
Powered by PunBB, supported by Informer Technologies, Inc.