It should be fine.
The printer will use less than 1A at 230V.
The power supply (that converts the 230V AC into 12V DC for the printer) can absorb a fair bit of noise that may be in the power line, e.g. from computers and fluoro lights, and is quite tolerant of line voltage variations. I wouldn't worry about this unless you have specific problems.
If you're concerned about losing prints if the power cuts out you can us a UPS, but if power outages are rare for you then there's little to no benefit of doing this.
SD3. Mk2b + glass, heated enclosure, GT2 belts, direct drive y shaft, linear bearings, bowden-feed E3D v5 w/ 0.9° stepper
Smoothieboard via Octoprint on RPi