1

Topic: Time for an Ord Bot only section?

Looks like it might be time to setup on Ord Bot section like the DeVinci section just to keep it all together.

SD2 - Glass Bed, Fans on PCB and Y motor, Custom enclosure
Slicer - Simplify3D

2

Re: Time for an Ord Bot only section?

wire10ga wrote:

Looks like it might be time to setup on Ord Bot section like the DeVinci section just to keep it all together.

+1

SD2 - Stock - Enclosure - Heated Bed - Glass Plate - Excess Heat Detection - Auto Fire Extinguisher
Ord Bot Hadron - RAMPS 1.4 - Bulldog XL - E3D v6 - 10" x 10" PCB Heated Build w/SSR - Glass Plate
Thanks for All of Your Help!

3

Re: Time for an Ord Bot only section?

But then I'd have to start posting all my details about Ords tongue

wink

4

Re: Time for an Ord Bot only section?

IronMan wrote:
wire10ga wrote:

Looks like it might be time to setup on Ord Bot section like the DeVinci section just to keep it all together.

+1

+1

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

5

Re: Time for an Ord Bot only section?

adrian wrote:

But then I'd have to start posting all my details about Ords tongue

wink

Think of it this way... It will keep you out of trouble wink

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions