1 Topic by cmetzel

  • cmetzel
  • Member
  • Offline
  • From: Solidoodle2 #0091
  • Registered: 2012-08-22
  • Posts: 1,429

Topic: Rodin's The Thinker Stutue Challenge

Some of you dialed in .1mm printers have a go at this one.  I'd love to see what this looks like and I think it would make it to the Solidoodle facebook feed if you got it done as well as I expect you could.

If you solidoodlesupport guys check back in, this would look good at 8" tall with a .1mm profile.  I bet you'd sell a lot with that on your homepage.

http://www.thingiverse.com/thing:34343

2 Reply by IanJohnson

  • IanJohnson
  • Moderator
  • Offline
  • Registered: 2012-08-07
  • Posts: 2,815

Re: Rodin's The Thinker Stutue Challenge

I think that would take about a week to print 8" tall at .1mm.

3 Reply by cmetzel

  • cmetzel
  • Member
  • Offline
  • From: Solidoodle2 #0091
  • Registered: 2012-08-22
  • Posts: 1,429

Re: Rodin's The Thinker Stutue Challenge

... all the better to show off with