Topic: Looking for firmware version 1.1.E
Looking for firmware version 1.1.E
This version allows me to hack the filament counter without getting a EEPROM Reset.
It would be great if someone could upload that.
Thank you.
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing DaVinci → Looking for firmware version 1.1.E
Looking for firmware version 1.1.E
This version allows me to hack the filament counter without getting a EEPROM Reset.
It would be great if someone could upload that.
Thank you.
I realize its been a month since your request, but someone has posted version 1.1.E here:
w w w dot dropbox.com/s/wjprf909wp86d3x/F10_20140221_FW_V1.1.E_RELEASE.bin
Looking for firmware version 1.1.E
This version allows me to hack the filament counter without getting a EEPROM Reset.
It would be great if someone could upload that.
Thank you.
really, how do you do that?
I realize its been a month since your request, but someone has posted version 1.1.E here:
w w w dot dropbox.com/s/wjprf909wp86d3x/F10_20140221_FW_V1.1.E_RELEASE.bin
The someone who posted the file was me.
If you looked a little lower in the post, you would have seen me thanking Jin for finding Version E
NeedsMoarTurbo wrote:I realize its been a month since your request, but someone has posted version 1.1.E here:
w w w dot dropbox.com/s/wjprf909wp86d3x/F10_20140221_FW_V1.1.E_RELEASE.binThe someone who posted the file was me.
If you looked a little lower in the post, you would have seen me thanking Jin for finding Version E
oh. Right on! I didn't know that, I just noticed it in the "software repository" of links over there and saw this post and thought I would try to close the loop for anyone else that might be looking for it. Thanks for posting it, its good to have helpful folks on these forums!
SoliForum - 3D Printing Community → XYZ Printing DaVinci → Looking for firmware version 1.1.E
Powered by PunBB, supported by Informer Technologies, Inc.