Topic: Chei Mei PA747 - Anyone used it?
Any experience, comments good or bad about the above anyone?
Thanks
Re: Chei Mei PA747 - Anyone used it?
I haven't run across it in pellets, but most ABS filament you buy from commercial 3D Printer suppliers will be PA747. MG94 is a more premium plastic, and is what Stratasys uses for their ABS.
Re: Chei Mei PA747 - Anyone used it?
Thanks for the comments Ian, I have noticed a few people in the UK using it.
Any other experiences any one?
Re: Chei Mei PA747 - Anyone used it?
I'll echo Ian. I haven't run it through a Filastruder, but no reason it shouldn't work fine. My research has shown its a very popular flavor of resin to use in 3D Printing.
Re: Chei Mei PA747 - Anyone used it?
Thanks Tim, theres a photo on this board of someone using it (theres a big sack of it next to the Filastruder).
If anyone else out there has any comments, they would be appreciated.
- CraigRK
- Member
- Offline
Re: Chei Mei PA747 - Anyone used it?
reesy wrote:
Thanks for the comments Ian, I have noticed a few people in the UK using it.
Any other experiences any one?
Hi Reesy, anyone in particular in the UK?
I'm looking for other UK Filastruder owners to try to co-ordinate efforts to get decent pellets.
Craig
Masterbatch, ABS and PLA Pellets available for UK and Europe.
http://www.emakershop.com/Seller=1324
http://www.emakershop.com/Seller=1324
Re: Chei Mei PA747 - Anyone used it?
Hello Craig,
I have noticed a few on this forum, and on youtube.
I dont think theres enough users in the UK (whilst Im British, I dont live there at the mo) to order a ton of them in and divide it up