1 Topic by bertmcintosh

  • bertmcintosh
  • Newbie
  • Offline
  • Registered: 2013-05-17
  • Posts: 4

Topic: Skeinforge in repetier???

So I've had my solidoodle for about a week now and I wanted to start using skienforge because it has the option to do external support only, but I can't get it to load the options menu in repetier.  and when I try to slice it always exits with error. 
I've tried deleting and reinstalling repetier but I don't think OSX is completely deleting it, because when I reinstall, all of my settings are still there. Including the bad setting for skeinforge.  Does anyone know how to delete repeiter and start fresh?  Thanks in advance!

2 Reply by bertmcintosh (edited by bertmcintosh 2013-06-03 03:46:55)

  • bertmcintosh
  • Newbie
  • Offline
  • Registered: 2013-05-17
  • Posts: 4

Re: Skeinforge in repetier???

So I've got skeiforge going in RH now but my extruder is putting out WAY to much plastic.  I mean like 50x as much as it should.   I've check that all of my settings match up with the default solidoodle config so now I'm stumped.
It also sets the print bed temp to 60 degrees???