1 Topic by mlove01001101

  • mlove01001101
  • Member
  • Offline
  • Registered: 2013-03-31
  • Posts: 38

Topic: Possible troubles with Start G-code.

I think I'm having trouble with mine.  I had my SD2 connected to an older desktop where it worked just fine, but I just connected to my new laptop, and all of a sudden it won't print.  The axes will home, and then it just sits in the ready position forever (I've had it sit for 45 minutes before disconnecting).  I'm not sure what's going on here, but I don't have any start or end G-code in Slic3r, so I figured that might be the issue. Thoughts?

2 Reply by fredhag

  • fredhag
  • Member
  • Offline
  • From: Richmond, VA
  • Registered: 2012-08-31
  • Posts: 38

Re: Possible troubles with Start G-code.

I'm sure it's an obvious thing you've already tested, but do you still have access to the older computer?  You could test the old PC for controlling the SD2, but you might also want access to the slic3r configs so you can transfer them to the new computer for a similar experience if you hadn't already done that.

Cheers,
Fred
Fredrick C. Hagemeister
http://blog.richmond.edu/ti3d

fredhag's Website

3 Reply by mlove01001101

  • mlove01001101
  • Member
  • Offline
  • Registered: 2013-03-31
  • Posts: 38

Re: Possible troubles with Start G-code.

Yes, that's exactly what I did.  Even then, it still just sits.

4 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: Possible troubles with Start G-code.

Can you give us a screenshot or copy the text in the lower log window of repetier that shows from when you hit connect?