1 Topic by thsorensen

  • thsorensen
  • thsorensen
  • Member
  • Offline
  • From: Norway
  • Registered: 2013-05-02
  • Posts: 19

Topic: Strange behavior with Slic3r - adds vertical edges.

Hi!
I've tried to print the balloon powered turbine (thingiverse.com/thing:47565). But when I slice it with Sli3r, it's get an extra edge around the turbine blades that should not be there (see the attached picture). Now the entire output too big/wide. Is there a setting in Slic3r that are doing this?

PS.
I got it working by using MakerWares gcode.

Post's attachments

Slic3rMW.jpg
Slic3rMW.jpg 155.52 kb, 1 downloads since 2013-05-13 

You don't have the permssions to download the attachments of this post.