RH manual tab

**satman49** · 2013-04-26 06:01:39

On that tab there are 2 sliders under Speed multiply feed rate and flow rate. Just what do they do and any need to adjust them?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

**pcpoirier** · 2013-04-26 08:27:07

Those are testing overrides

**ysb** · 2013-04-26 12:59:52

or real time correction...

Speed multiply feed rate change the speed of your print.. and flow rate change the amount of plastic that you put in your print..

so you can do fine tuning (i use it often to slow my print on "difficult" zone of my model... or to speed up on simple large zone..) ..

my kissclicer gcode dont do thing like my slic3r gcode for the same model... so i use also the slider depênding of the flavor of gcode i use...

Find all my 3D printable models here
Game of ropes 2 online..Adult only

**pcpoirier** · 2013-04-26 13:13:53

Posts: 4