Topic: Modified Solidoodle 3 + loads of filament
It's been awhile since I've posted here, more so since I posted anything about the solidoodle printer in general. A few years ago, I migrated to resin printers, and since then I haven't use the Solidoodle at all.
So I think it's time for it go to a home where it could get some use.
So what's in the package:
1. Highly modified Solidoodle 3 (I've posted many threades about my mods).
RAMPS 1.4 w/ DRV8825 Extruder stepper driver (1/32).
750W Server PSU w/ front, lighted Power Switch.
Graphic LCD controller.
Ball Screw and nut for Z drive.
Aluminum Print platform w/ full Copper Print bed and MK2A Heater.
GT2 belts, sprockets and idler pulleys.
Chrome hardened 8mm shafts.
Chrome hardened 6mm "Y" drive shaft w/ flanged bearings and Pillow Block.
Side opening Chain carrier for the print head wiring.
Custom "X" carriages w/ linear bearings.
Custom extruder carriage w/ linear bearings.
Custom "Y" motor belt tensioner.
Larger Extruder motor (Kysan 1124090).
40W Heater cartridge for Hot end.
G-Code controlled Cooling fan & duct
It looks almost identical to this earlier version (Some additional mods to the print head (more efficient cooling)
2. At least 10 rolls of filament. All ABS (was never a big fan of PLA), in various colors
Caveat:
I will not ship all this stuff, just too much bulk and weight. This one is pickup only in the San Francisco Bay Area. So if you're local, give me shoutout, either here on this thread or to my email: [email protected]
Oh, yes, price.... Make me an offer
SD3 printer w/too many mods, Printrbot Simple Maker Ed., FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.