Re: XYZ Firmware Flash Tool [Downgrade daVinci to any older Firmware]
Yes, if you would have the Repetier firmware for Nano (or if someone would write such firmware).
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing Hacks & Mods → XYZ Firmware Flash Tool [Downgrade daVinci to any older Firmware]
Yes, if you would have the Repetier firmware for Nano (or if someone would write such firmware).
I use xyz Firmware Flash tool v1.95 and my da Vinci Minimaker has Firmware 1.1.4 installed.
Whenever I try to downgrade to 1.1.1 or upgrade to 1.2.4 the program reports success
but the printers led stays RED for a very long time. After serveral minutes I press it and it
turns green again and the flash tool reports it still has 1.1.4... so no success
I am running the software in win11 and I tried to elevate the program to admin but no luck.
The daVinci miniMaker with fingerprint dv1MX0B000 (not dv1MX0A000) is or use some Demo firmware. It can use third-party filaments.
Seems there are two different printer being sold as "da Vinci miniMaker"
dv1MX0A000 - latest firmware 1.2.4 - can NOT use third-party filaments
dv1MX0B000 - latest firmware 1.1.4 - CAN use third-party filaments
But the hardware is 100% identical.
It is while ago, but if I remember well, it's possible to convert (cross flash) the dv1MX0B000 to dv1MX0A000.
First you have to flash (use my tool) v1.1.5 then v1.2.4. (after flashing 1.2.4 your printer will be recognized as dv1MX0A000).
You can anytime recover or go back to 1.1.4
Use this http://www.soliforum.com/topic/17845/do … rmininano/
SoliForum - 3D Printing Community → XYZ Printing Hacks & Mods → XYZ Firmware Flash Tool [Downgrade daVinci to any older Firmware]
Powered by PunBB, supported by Informer Technologies, Inc.