1 Topic by rockyrude

  • rockyrude
  • Member
  • Offline
  • Registered: 2016-02-22
  • Posts: 11

Topic: xyz davinci 2.0 issues

I have had my davinci 2.0 for about 5 years now and have primarily used abs. I now want to change to pla and the printer is having issues with it. Running proper temps for pla but mid print the filament stops extruding. I don't have these problems with abs.

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: xyz davinci 2.0 issues

there is a section of the forums specifically for the XYZ machines, including DaVincis - you may have better luck getting your questions answered there, rather than in the general

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1