Topic: EEPROM Edit Tool - [DaVinci 1.0/1.0A/2.0A/Duo/AiO/Pro/Plus/....]
Today I would like to share my other windows program to make your life easier.
Thanks to "cgrillo" for his help and source snips, which helped to finish this project.
This program will allow you to edit EEPROM parameters and/or generate valid data for DaVinci series.
Output files can be saved as binary or text file. Updates will be available over the program and on this forum.
There might be few bugs or mistakes, let me know to fix them. Optimizations or suggestions are welcome.
Compatible Models:
- daVinci 1.0
- daVinci 1.0A
- da Vinci 2.0A
- da Vinci Duo 2.0
- daVinci AiO (1.0)
- da Vinci Pro
- da Vinci 1.1 Plus
Download Link to EEPROM_Edit_Tool v1.78 https://my.hidrive.com/share/eo8f39xpz9
As usual, small hardware is needed to program the EEPROM (Microchip 11AA010 UNI/O Serial EEPROM), here is an example:
Program naked/new Arduino Nano v3:
- first install the drivers (CH34x or FTDI)
- connect the Arduino Nano v3 to PC with USB cable
- open the software "EEPROM_Edit_Tool.exe"
- open the Recovery/Factory programming menu by holdung [Ctrl] key and mouse click to connect button
- select the COM port of your Arduino Nano
- press the Update button, new firmware will be flashed (no mater of new/old bootloader)
Some screenshots of the tool:
Use the EEPROM Resetter/Reader with PC:
- first install the drivers (CH34x or FTDI)
- connect the "EEPROM Reader" to PC with USB cable
- open the software "EEPROM_Edit_Tool.exe" and press to connect button
- press generate button to create parameters and/or modify like you wish
- connect the cartridge with "EEPROM Reader"
- press write button to write the parameters to the cartridge chip
Use the EEPROM Resetter/Reader as standalone:
- connect the "EEPROM Reader" to powersupply or battery
- press the button one time (short), to wake up device
- connect the cartridge with "EEPROM Reader"
- press the button short again, LED will flash twice and turn off
- Remove the "EEPROM Reader" out of the cartridge and install it in your 3D printer
This way will refill your Filament length to 240m, increase the serial number by one and keep your Filament type as it is.
The favorite settings can be changed with this tool too.
Here are some pics how the final EEPROM Resetter/Reader could look like: