Topic: Setting up problem motor and lasers not operating
Hi, I bought a kickstarter kit way back and finally got around to printing and building the kit. I have got to this point and need some help.
The kit is fully built and connected (and accessible) via wifi.
The check for update link does not work.
Camera functions correctly
Both Lasers do not turn on
The stepper motor does not turn on
To get to this point I have
--Replaced the SD card - the pre loaded software did not work and I was unable to write to the card using etcher or disk utility on MacOS
--Bought an 8mega pixel pi cam as there was no camera included in the kit
--Upgraded the power supply from the 5V 2.5A to a 5V 4A
Does anyone have any ideas of what I should try next?
Any help will be gratefully appreciated