I cant get slic3r to work

Does it heat when you use the preheat function from the menu?

I ran one line and it worked fine . Oh yea and my first print with slic3r worked fine . I did tinker with the filament settings. but all I did was turn off fans , since Im printing with abs

Post your complete start gcode as is. Let's see what it is doing?

oh sorry https://docs.google.com/document/d/1kCZ … sp=sharing ???

it works when I preheat . If after I start preheating I start the print the bed tempature heats to what I set in slic3r  instead of what it normally preheats to . I cant know if its the same with the nozzle because I have that set to what the printer preheats to

I dont think so , because when I print without preheat it says I set the nozzle to 0 so no heat . But when I first preheat and then print itl heat the nozzle to the tempature when it normally preheats . Im lucky that the tempature I was going to print with was the same as when it preheats (not from slic3r)

I have had a similar problem with Slicer, Slicer PE, and Cura.

If I start a print and I"m not already at or above the start temps for both bed and extruder, it just sits there and does not heat up to temp. I've used all three of these slicers and upload to Octoprint. I just have my pre-heat temps a few degrees above my print temp. As long as I don't start a print before it reaches temp, it works fine.

I assume it's my start gcode but it looks good to me and my workaround is easy enough.

for windows

interesting.