1 Topic by Vixx

  • Vixx
  • Newbie
  • Offline
  • Registered: 2020-05-08
  • Posts: 8

Topic: Certer section of scans bulged.

When attempting scans I notice in the previews that the center area of the scan (center of the turntable axis and 2-3 inches up) the geometry is bulged outward in all direction, this persists in lit and unlit scans as well as through numerous calibrations.  Is this a sign of a defective camera or incorrect setting on my part?

2 Reply by hairu526

  • hairu526
  • Member
  • Offline
  • Registered: 2014-01-28
  • Posts: 494

Re: Certer section of scans bulged.

Hi Vixx,

It does sound like you have a calibration issue.  Can you post a picture of the preview?  Also, are you using the double checkerboard calibration?

Regards,
Uriah

3 Reply by Vixx

  • Vixx
  • Newbie
  • Offline
  • Registered: 2020-05-08
  • Posts: 8

Re: Certer section of scans bulged.

hairu526 wrote:

Hi Vixx,

It does sound like you have a calibration issue.  Can you post a picture of the preview?  Also, are you using the double checkerboard calibration?

Regards,
Uriah

I am using the double checkerboard, unfortunately I don't have any previews saved to post, I'll be sure to get one next time I try to scan.