1 Topic by Nepenthy (edited by Nepenthy 2020-05-30 13:55:57)

  • Nepenthy
  • Newbie
  • Offline
  • Registered: 2014-10-31
  • Posts: 1

Topic: Repetier firmware (Luc) 0.92

Hi All. Ive been running Luc's repetier firmware on a davinci 1 for around 4 years without issue. Recently i had to replace my bed and thermistor. Im using this heater/thermistor: https://www.amazon.com/gp/product/B0711 … &psc=1

1 Piece of NTC 100K Sensor -  This, once installed, reports my heatbed at 74c without being turned on. I know i need to upload a new table for this.

The problem is I havent flashed this thing in over 4 years. While Im sure the process will come back to me quickly, i dont want to lose my current settings.

Is there any way to dump out current firmware and use that as a base. Back on Voltivo forums Luc had assisted me with a couple settings, and now I cant remember what they were.

Is there any way to dump out current firmware? And if Im super lucky, does anyone already have a table built for this type of thermistor?

As a workaround, I could add new wires to the stock thermistor, and tape it to the bottom on the heat plate. Id rather not do that, but it may end up being the safter alternative if you cant dump out existing firmware.

Any help is greatly appreciated. Thank you!

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Repetier firmware (Luc) 0.92

The only to dump is to a BIN file which you cannot read. So in short no you can't save your firmware settings.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.