1 Topic by tpattonjr (edited by tpattonjr 2017-06-20 07:13:19)

  • tpattonjr
  • Newbie
  • Offline
  • Registered: 2017-06-20
  • Posts: 2

Topic: Da Vinci 1.0 A 3d printer: HELPPPPPPP!

I was clearing out a clogged nozzle and upon reassembling I broke a tab off the plastic piece that holds the extruder in place while printing. Does anyone have spare they'd like to sell? Im offering $15 plus I pay for shipping.

XYZPRINTING tells me that they dont have a replacement part, these guys aren't too good when it comes to PR!


http://soliforum.com/i/?FpFvi6y.jpg

Please let me know asap because I cannot print until I have it fixed

AND THANK YOU FOR LOOKING T THIS POST-

2 Reply by deon.eksteen

  • deon.eksteen
  • Newbie
  • Offline
  • Registered: 2016-10-13
  • Posts: 8

Re: Da Vinci 1.0 A 3d printer: HELPPPPPPP!

Hi tpattonjr

Haha your printer rejected the stock hot-end assembly and is begging for an upgrade smile It's high-time you to do some high quality prints.
https://www.thingiverse.com/thing:1510425

Regards
Deon

3 Reply by Pete49

  • Pete49
  • Member
  • Offline
  • Registered: 2015-11-09
  • Posts: 45

Re: Da Vinci 1.0 A 3d printer: HELPPPPPPP!

Use a zip tie to hold it in place.
Pete

4 Reply by dochoppy

  • dochoppy
  • Newbie
  • Offline
  • Registered: 2015-05-27
  • Posts: 6

Re: Da Vinci 1.0 A 3d printer: HELPPPPPPP!

PM me, I have a spare part I can send you.

5 Reply by pararoglu61

  • pararoglu61
  • Newbie
  • Offline
  • Registered: 2020-05-08
  • Posts: 1

Re: Da Vinci 1.0 A 3d printer: HELPPPPPPP!

Hey there I have the same problem. same think have been broken. Is there any one had the 3d model of it ?