1 Topic by tracks479

  • tracks479
  • Newbie
  • Offline
  • Registered: 2019-04-05
  • Posts: 2

Topic: Da Vinci JR -> RAMPS 14

Hi,
Before anything else i'm sorry for my english because i'm a french student and for my personnal issues i'm converting my DA VINCI JR 1.0 printer to RAMPS.
After many times i didn't solve my problems;
When i'm trying to move the Z stepper motor or the X stepper motor, there are "shaking", anything move and it's causing a lot of noise.
For the moment, i reached the forum for a solution and i didn't find it...
Could you help me ? Thank's smile

I'm using Marlin V1.1.5

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Da Vinci JR -> RAMPS 14

Motor phases are wired wrong. They are marked on the output ports of the board. Make sure they match on the motor
Your vref could also be low for those motors. If you have an axis that works then wire all axis like that one and set the vref for all to the same as the working axis.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by tracks479

  • tracks479
  • Newbie
  • Offline
  • Registered: 2019-04-05
  • Posts: 2

Re: Da Vinci JR -> RAMPS 14

I checked my connexions and all is ok.
I have the same vref in my configuration.h
I upload this video with my problem :
And this is my configuration.h

https://www.dropbox.com/s/k3xjwirgkdwx6 … ion.h?dl=0