1 Topic by emanuele.soncin (edited by emanuele.soncin 2020-04-03 07:25:16)

  • emanuele.soncin
  • Newbie
  • Offline
  • Registered: 2020-04-03
  • Posts: 2

Topic: Problems with cura Settings

Hi,

I am using XZYPrinting SW but I'm not totally satisfied, so I'm trying to use Cura (which I have already used in the past). I have problem with the configuration, I can not set Printhead settings, they always get back to the pre set one.
I am using a custom printer configuration.
If I try to slice, in Cura it looks ok but when I charge in XZYPrinter it shows only the first slice and out of the printing area.

I tried with a Mac and 2 windows 10, the results are the same, it shows in Printhead X min -20, Y min -10 and I cannot change these values.

Thanks for your help
Emanuele

2 Reply by redkurn

  • redkurn
  • Member
  • Offline
  • Registered: 2020-03-01
  • Posts: 10

Re: Problems with cura Settings

first you need to get your da vinci as level as possible, i've gotten mine to calibrate to a zero offset.

i've got loads of configs for printing after lots of trial and error, if you are having trouble with the printer settings itself xyz made a pdf for that.

i have the jr 1.0 w, also found a loophole with the chipped filament, you should start here and help if you need more.
https://www.xyzprinting.com/en-US/news/ … -with-cura
http://www.soliforum.com/topic/18456/da … e-248-bug/