1 Topic by ebsigma

  • ebsigma
  • Member
  • Offline
  • Registered: 2017-08-04
  • Posts: 41

Topic: doubt printing with minimover

I have an emutag, if I print with minimover a file generated with a cure, is it subtracting me meters of filament in the tag?

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: doubt printing with minimover

ebsigma wrote:

I have an emutag, if I print with minimover a file generated with a cure, is it subtracting me meters of filament in the tag?

Yes it does then you just reset the tag before it reaches zero or the printer flags it as empty.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by ebsigma

  • ebsigma
  • Member
  • Offline
  • Registered: 2017-08-04
  • Posts: 41

Re: doubt printing with minimover

Yes, that is what I do, it is in case the meters did not always go down to use minimover, but seen the seen I use the official software that prints me better than cure (for not having to configure so much)
thanks!