1 Topic by danijelfurjan3

  • danijelfurjan3
  • Member
  • Offline
  • Registered: 2019-10-05
  • Posts: 21

Topic: Question

http://soliforum.com/i/?ev1pf5Z.jpg



through which program to inject this so I can test the temperature

2 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Question

You need the stl of that then put it into your slicer/host program and have the slicer send it to the printer.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.

3 Reply by danijelfurjan3

  • danijelfurjan3
  • Member
  • Offline
  • Registered: 2019-10-05
  • Posts: 21

Re: Question

i have a stl of that but the writer is still running at 210, not changing the temperature ..

4 Reply by carl_m1968

  • carl_m1968
  • carl_m1968
  • Member
  • Offline
  • From: Far North almost not Dallas
  • Registered: 2014-10-17
  • Posts: 6,512

Re: Question

danijelfurjan3 wrote:

i have a stl of that but the writer is still running at 210, not changing the temperature ..


You have to have software that allows you to program temp changes at various levels. The software your machine runs on does not allow this nor can you change the temps unless you change the controller to something like a Ramps 1.4. On your machine the fialment chip sets the temp and it is controlled by the color.

Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.