1 Topic by Sammy50

  • Sammy50
  • Newbie
  • Offline
  • Registered: 2019-12-21
  • Posts: 7

Topic: Santa Claus Modeled in SelfCAD

We modeled this Santa Claus for celebrating Christmas. The Software used is SelfCAD https://www.selfcad.com.
You can download the files Thingiverse https://www.thingiverse.com/thing:4033978.

http://soliforum.com/i/?Wxedn1B.png


http://soliforum.com/i/?xjymDJZ.png

Your feedback is highly welcomed!

2 Reply by heartless

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Santa Claus Modeled in SelfCAD

cute, but the top of the hat is going to be difficult to print properly.

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1