1

Topic: problems uploading images

I'm having problems uploading an image.  When I clik upload, I get the selection box, I select and image, and a couple of seconds later I get  and error:

Sorry! The page could not be loaded.
Page Not found (Error 404):
The requested page imgupload.php could not be found.

Is this a problem on my end?  I doesn't look like it. 

Can someone look into this?

P.S.  trying to add an attachment doesn't work either.  No error, but the when you click on "add File, the compose post area reset to a blank.

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.

2

Re: problems uploading images

http://soliforum.com/i/?Yi9MvDd.jpg
Random test picture

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

3

Re: problems uploading images

Seems to be on your end

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

4

Re: problems uploading images

testing..


http://soliforum.com/i/?hH2jjGU.png

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

5

Re: problems uploading images

no problems here

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

6

Re: problems uploading images

not anymore for me either.

I had restarted the computer, and tried 3 different browsers, but they were all doing the same thing.  I then tried a different computer and that worked fine.

Then I tried it again an hour later and it worked.  Go figure.!

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.