Topic: Semplify 3d question
which is best to use prime pillar or ooze shield.
I am printing PETG with a dual extruder.
Thanks
Dale
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → General Discussion → Semplify 3d question
which is best to use prime pillar or ooze shield.
I am printing PETG with a dual extruder.
Thanks
Dale
Depends on the print but I typically prefer prime pillar. I usually set my pillar 10mm square far out in a corner. This works well if your non print travel speeds are at least 80mm/sec.
and it is sImplify3D not semplify.
Heartless
Keep your grammar check to yourself!!
Dale
SoliForum - 3D Printing Community → General Discussion → Semplify 3d question
Powered by PunBB, supported by Informer Technologies, Inc.