1 Topic by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: G-code flavor in Silc3r

There are several choices , which is best?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: G-code flavor in Silc3r

Since the SD uses Marlin firmware you should slice with the reprap/marlin gcode setting so the SD understands what you want to do.