Topic: E3d v6 clone and anet a8 help
Hey everyone. This is my first time posting. I've had an anet a8 for a while now and finally decided to go bowden. I picked up a e3d v6 clone and put it together today. The one thing I couldn't figure out is how to wire the clip on fan to the fan connector on my board. The fan it came with had plain striped ended wires but the board is a plastic 2pin connector. I finally decided just to splice the new wires with the wires from the old fan connector. This was working for two small prints untill it shorted and melted the insulation down the whole length of the wire. Luckily I was home and had installed a power switch so nothing caught fire. What do you think I did wrong? Is there a better way of doing this. Thanks for your help