Topic: anyone have a spare ribbon cable for the hot end on the jr?
mine broke
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → XYZ Printing Help/Repair/Maintenance → anyone have a spare ribbon cable for the hot end on the jr?
mine broke
mine broke
You could just make one using normal ribbon cable. It would probably last longer. These machines are too new for people to have spares yet.
I think this cable should work for you. You'll probably have to pull off the connector on the circuit board end, but those connectors should just un-clip from the ribbon cable.
SoliForum - 3D Printing Community → XYZ Printing Help/Repair/Maintenance → anyone have a spare ribbon cable for the hot end on the jr?
Powered by PunBB, supported by Informer Technologies, Inc.