1 Topic by terian1gregory

  • terian1gregory
  • Newbie
  • Offline
  • Registered: 2018-04-22
  • Posts: 1

Topic: y axis problem on 2.0 duo

when extruder goes to the right to the home position it makes a terrible noise and then an error 0031 issue comes up  i am at a loss i do not know if it is the motor or the sensor any help would be welcome i am quite new to this

2 Reply by yizhou.he

  • yizhou.he
  • yizhou.he
  • Member
  • Offline
  • From: Boston, MA
  • Registered: 2017-07-05
  • Posts: 1,322

Re: y axis problem on 2.0 duo

most likely the endstop (sensor) is not triggered, and most likely due to faulty wire harness.

(Da Vinci 1.0, Jr. 1.0 RAMPS, miniMaker) X4, (Creality CR-10S, CR-10 mini, Ender-3) X4, Anycubic MEGA X4, Anycubic Chrion X1, ADMILAB Gantry X2 (MonoPrice Maker Select V2, Plus, Ultimate)X4--Select mini X1, Anycubic photon X4, Wanhao duplicate D7 X1.
iNSTONE Inventor Pro X2, CTC Dual X2, ANET-A8, Hictop 3DP-11, Solidoodle Press, FLSUN I3 2017X1