1 (edited by pirvan 2018-02-10 15:55:52)

Topic: I AM THE LAW ! - FINISHED

Recently I found a cool bust of Judge Dredd. The helmet and armor are from the latest Dredd movie starring Karl Urban, but it had an ugly generic head with a huge jaw.

I also happened to have a caricature model of Sly Stallone, so just like when you drop chocolate into your peanut butter, the 2 models were asking for a mashup.  But this made sense only if I could make the helmet removable so you could see the face, so after a little bit of work, I present Judge Dredd...  " I AM THE LAW ! "

I was originally going to paint the complete model in color, but after painting the helmet and seeing it against the rest of the model in flat black, I think I’ll paint the head and armor in shades of gray, to make it look like a black and white photo.

Here is what I have so far. I’ll be painting the head and the next few days and post the final results.

http://soliforum.com/i/?mpalyR3.jpg

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.

2

Re: I AM THE LAW ! - FINISHED

freaking awesome

Sd4 #9080 with a glass bed. E3d chimera duel extruder. Paste extruder , duet wifi.
Lawsy carriages. linear bearings. Y axis direct drive, Kinect scanner
SD4#8188 glass bed, lawsly carriages, E3d v6, octoprint http://www.ustream.tv/channel/hotrod96z28
Filastruder/filawinder, Custom Delta 300mm x 600mm

3

Re: I AM THE LAW ! - FINISHED

I like!

4

Re: I AM THE LAW ! - FINISHED

Looks great!!

Ultimaker S3.

5

Re: I AM THE LAW ! - FINISHED

That's really nice.

6

Re: I AM THE LAW ! - FINISHED

very cool!

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1

7 (edited by pirvan 2018-02-10 16:16:14)

Re: I AM THE LAW ! - FINISHED

Here is the finished model


http://soliforum.com/i/?Pv5Qy00.jpg

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.