carl_m1968 wrote:Those will not work on an xyz machine. XYZ has the pull-up and current limiting resistors for each Ir LED and opto-transistor for each end stop on the main board. The ones you have listed has those resistors on each unit. If you use them as is in an xyz machine the resistance and current will be too low for them to operate.
I think you are correct, XYZ has the pull-up and current limiting resistors for each Ir LED and opto-transistor for each end stop on the main board. The voltage supposed to be ~5V/~0.2V with stock optical endstop on/off, I got ~3.3V/0.1V instead without remove the pull-up and current limiting resistor. It still works well since 3.3V still considered high voltage. I think just replace the Ir LED and optical-transistor from the new endstop with solder iron to replace the old one is a better choice. It is technical challenging, but it is not expensive and risk of get anything burned is low. Worth to try when out of choices.
(Da Vinci 1.0, Jr. 1.0 RAMPS, miniMaker) X4, (Creality CR-10S, CR-10 mini, Ender-3) X4, Anycubic MEGA X4, Anycubic Chrion X1, ADMILAB Gantry X2 (MonoPrice Maker Select V2, Plus, Ultimate)X4--Select mini X1, Anycubic photon X4, Wanhao duplicate D7 X1.
iNSTONE Inventor Pro X2, CTC Dual X2, ANET-A8, Hictop 3DP-11, Solidoodle Press, FLSUN I3 2017X1