Topic: Daul Extruder is Switching heads by itself
I am using Cura to slice the .stl file to the gcode file. I have a Prusa i3 pro C duall extruder, and I'm using OctoPi to control the printer. This problem has happened three times now. I start working on the dual extruder. I slice a file for dual extrusion and load it to Octopi. It starts the print correctly printing with Tool 0 as extruder 1, prints the brim and the first layer for extruder 1, stops then switches to Tool 1 as extruder 2, and prints the first layer for extruder 2. I have to stop it as this point because I don't have the offset correct yet. Then I slice the .stl file again and reprint. I can do that 2 only a few times before extruder 1 switches to Tool 1 by itself. Problem: Cura or Octopi is switching Extruder 1 to Tool 1, not Tool 0.
Can someone help me figure out where this switch is happening at? Is it in the .gcode that extruder 1 is being switched to Tool 1?