1 Topic by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Topic: 449 layer print

I am printing this at .1mm  says its will take over 4 hrs , is that about normal?

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

2 Reply by jon_bondy

  • jon_bondy
  • Member
  • Offline
  • Registered: 2012-09-27
  • Posts: 405

Re: 449 layer print

If the part is wide enough, yes.  I have printed 12 and 15 hour prints before.

3 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: 449 layer print

I get about an hour and ten minutes per hundred layers on my .1mm x 5 perimeter x .20 infill profile for objects that are about two inches by 4 inches... so seems about right.