1 Topic by poulan (edited by poulan 2017-07-05 23:52:28)

  • poulan
  • Member
  • Offline
  • Registered: 2014-04-27
  • Posts: 42

Topic: Fitted an E3D lite6 to SD 4 and...

...I literally have no idea how to update the printer firmware to complete the installation. It does seem to work without doing anything (I only heated it up in order to tighter the hot end as per the instructions) but the last steps in the software/firmware I am stuck on.

Does anyone know what I need to change to finish the install of of the E3D light on the SD 4?

2 Reply by Kronikabuse

  • Kronikabuse
  • Kronikabuse
  • Member
  • Offline
  • From: Wi
  • Registered: 2014-08-03
  • Posts: 709

Re: Fitted an E3D lite6 to SD 4 and...

you need to update the firmware. http://www.soliwiki.com/Updating_Solidoodle_Firmware

Sd4 #9080 with a glass bed. E3d chimera duel extruder. Paste extruder , duet wifi.
Lawsy carriages. linear bearings. Y axis direct drive, Kinect scanner
SD4#8188 glass bed, lawsly carriages, E3d v6, octoprint http://www.ustream.tv/channel/hotrod96z28
Filastruder/filawinder, Custom Delta 300mm x 600mm