Topic: Davinci 1.0 E3D V6 Easy Direct Fit Direct Drive
Hello All,
After using all the info that I have gained from here I thought that it is time to contribute something back. I know that the 1.0's are a little dated but IMO it still is a great printer, even more so with good mods. I did not like many of the E3D mods that I have seen, they either require holes to be drilled or additional hardware or replacement of the whole carriage. I wanted something easier that would just install and work. I optimized the parts as best as I could to reduce support requirements when printing. This configuration uses the stock screws that hold the hot end in and the stock E3D parts from the kit.
I went a little overboard with the wiring and modifications to the main board but that is not necessary and just satisfied my OCD.