Topic: Print head catching on first layer. Tangled mess.
Recently received a little used XYZ Davinci 1.0A.
Successfully printed a sample and one design.
Now the print head when passing over the first layer is catching on it and turning it into a mess. It is also leaving little tails when it goes from once spot to the next.
Calibrated the bed with the inbuilt calibration and tried the manual method with the sheet of paper too but no luck.
Cleaned the head with a wire brush and cleaned the bed and put some glue on it. The machine is stock with no mods or hacks using standard ABS cartridge.
It has traveled in the car and been moved around a bit if that messes with calibration although i have calibrated it before use.
Cheers