Topic: checking moisture content
I read moisture content should be between 50ppm and 250ppm before extruding. What is the name of the tool used to measure this?
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Filastruder → checking moisture content
I read moisture content should be between 50ppm and 250ppm before extruding. What is the name of the tool used to measure this?
Some polymers are more sensitive to moisture than others. It is fairly difficult in practice to measure moisture content of a polymer especially for the home DIY'er. Better to just dry the raw material prior to extrusion, if it is a polymer with high moisture sensitivity (like PLA).
There are moisture analyzers I have seen and worked on a few for customers that produce polymers. These are precision electronic balances with a heater and controls built in. You weigh a sample then set the heat temp and timer then reweigh. These are expensive lab devices. Not made for home use.
I was hopping more for a, buy this device, stick it in your bag, wait 10 minutes (or whatever) and read the gauge. sigh....
SoliForum - 3D Printing Community → Filastruder → checking moisture content
Powered by PunBB, supported by Informer Technologies, Inc.