Topic: could use a little advice on Titan/Volcano combo
So I recently got the E3D Volcano with a 0.6mm nozzle and Titan extruder installed on my FT-5 and attempted my first print last night - it started out OK, but quickly went downhill
Firmware was updated for the Volcano and E Steps/mm were set - when I ask for 100mm, I get 100mm
What I am not sure about is temp range, max extrusion volume, and anything else I may need to adjust to get successful prints with this thing...
this was PLA set about 210-215C
as you can see, the first few layers look fine, but then...
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1