1 Topic by ytt1300

  • ytt1300
  • Newbie
  • Offline
  • Registered: 2015-08-06
  • Posts: 4

Topic: e3d v6 workbench firmware

Now that SD is no more, how do i upgrade my workbench firmware?  My E3d's are in route right now and i've printed the new spacer and mount, just need the software...

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: e3d v6 workbench firmware

I find it easier to download the latest Marlin from Git hub and configure it myself.  That's all SD basically did.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by ytt1300

  • ytt1300
  • Newbie
  • Offline
  • Registered: 2015-08-06
  • Posts: 4

Re: e3d v6 workbench firmware

I did stumble onto the software on github, just wasn't sure it was workbench specific or the latest.  Is the installation guide on the soliforum wiki the same process for the workbench?

Thanks

4 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,623

Re: e3d v6 workbench firmware

I used Marlin-Dev the last time I flashed my Workbench.  But like I said before you'll need to configure it for for your machine.  I'm sure there's a WorkBench preconfigured version floating around somewhere.

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

5 Reply by walkie20

  • walkie20
  • Member
  • Offline
  • Registered: 2015-01-20
  • Posts: 28

Re: e3d v6 workbench firmware

Hi ytt1300, Did you find the Workbench Firmware? I am in the same boat... just switched to the E3D and need to flash the firmware to get the machine running again...Did you find the Workbench Firmware? I am in the same boat... just switched to the E3D and need to flash the firmware to get the machine running again...