1 Topic by kimf

  • kimf
  • Newbie
  • Offline
  • Registered: 2016-01-19
  • Posts: 1

Topic: Extruder screw DaVinci Jr

I am completely new to 3d printing.  When I was removing the filament guide tube to clean the extruder the screw at the top of the extruder fell out.  Is there a way to open the extruder to reconnect it.   

Thank you!

2 Reply by Rob68

  • Rob68
  • Member
  • Offline
  • Registered: 2015-12-17
  • Posts: 14

Re: Extruder screw DaVinci Jr

I opened mine last week...just gently pry up those 2 small clips on top of the extruder and it'll open up