Topic: New Products
I've been away from the Forum for a while. Life has a way of directing your attention and at times it can't be ignored. Anyway..
A few people had trouble when installing the glass that I sell.
Seems the power supply on the DaVinci 1.0 series is marginal for the printer and when installing my glass/ heater it would trip the PSU off when powering up. The combination of extruder, heated bed and steppers would pull too much power and cause the PSU to shut down.
I know one solution is to install a higher watt PSU but it requires cutting and splicing wires as well as you're left with a lot of wires that aren't used.
In response to this problem I've developed a Plug N Play solution using a 350watt power supply.
I'm in the middle of torture testing now and they should be available next week.
Of course I have to add a link to the site where it can be purchased. www.davincizone.com
If I've offended anyone or broken any rules, please let me know and I will remove this.
Regards,
James